| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Window/Glass | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002SU000EX |
| Title: WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL (2008 LX570) | ||
REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
3. REMOVE REAR UPPER DOOR ARMREST BASE PANEL
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
5. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP
6. REMOVE REAR SPEAKER SET
7. REMOVE REAR DOOR SERVICE HOLE COVER
8. REMOVE REAR DOOR GLASS RUN
9. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY
10. REMOVE REAR DOOR QUARTER WINDOW GLASS
11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY
12. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
13. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
|
(a) Using a T25 "TORX" driver, remove the 3 screws and motor. NOTICE:
Be careful when removing the screws as the motor may fall and become damaged. |
|
|