|
Last Modified: 11-27-2007 |
1.6 A |
|
Service Category: Drivetrain |
Section: Axle/Differential |
|
Model Year: 2008 |
Model: LX570 |
Doc ID: RM00000306N005X |
|
Title: AXLE AND DIFFERENTIAL: REAR AXLE HUB BOLT: REPLACEMENT (2008 LX570) |
REPLACEMENT
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
1. REMOVE REAR WHEEL LH
2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH
3. REMOVE REAR DISC LH
4. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING LH
5. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
6. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
7. REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH
8. REMOVE REAR AXLE HUB BOLT LH
|
(a) Using SST and a screwdriver or equivalent to hold the axle hub, remove the hub bolt.
SST: 09650-17011
NOTICE:
-
Do not deform the oil deflector.
-
Make sure to align the notch of SST with the flange of the oil deflector.
|
9. INSTALL REAR AXLE HUB BOLT LH
|
(a) Temporarily install a washer and hub nut to a new hub bolt as shown in the illustration.
NOTICE:
Install a hub nut to prevent damage to the hub bolt.
|
(b) Using a screwdriver or equivalent to hold the hub, turn the hub nut until the bottom surface of the hub bolt head touches the axle hub.
(c) Remove the washer and hub nut.
NOTICE:
Do not damage the threads of the hub bolt.
10. INSTALL PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH
11. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
12. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
13. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING LH
14. CHECK PARKING BRAKE INSTALLATION
15. INSTALL REAR DISC LH
16. CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH
17. CHECK PARKING BRAKE LEVER TRAVEL
18. ADJUST PARKING BRAKE LEVER TRAVEL
19. INSTALL REAR WHEEL LH
Torque: 131 N·m (1336 kgf·cm, 97 ft·lbf)
|