| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Drivetrain | Section: Transfer/4wd/Awd | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000030J2006X |
| Title: JF2A TRANSFER / 4WD / AWD: 4WD CONTROL ECU: REMOVAL (2008 LX570) | ||
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
3. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH
4. REMOVE FRONT DOOR SCUFF PLATE RH
5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
6. REMOVE COWL SIDE TRIM BOARD RH
7. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
8. REMOVE INSTRUMENT PANEL BOX DOOR KNOB
9. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
10. REMOVE 4WD CONTROL ECU
|
(a) Disconnect the 2 ECU connectors. |
(b) Remove the bolt and ECU.
|
|