| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Drivetrain | Section: Axle/Differential | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003184006X |
| Title: AXLE AND DIFFERENTIAL: REAR DIFFERENTIAL CARRIER OIL SEAL: REPLACEMENT (2008 LX570) | ||
REPLACEMENT
1. DRAIN DIFFERENTIAL OIL
2. DISCONNECT PROPELLER SHAFT ASSEMBLY
3. REMOVE DRIVE PINION COMPANION FLANGE REAR NUT
|
(a) Using SST and a hammer, loosen the staked part of the nut. SST: 09930-00010 |
|
(b) Using SST to hold the companion flange, remove the nut. SST: 09330-00021 09330-00030 |
4. REMOVE REAR DRIVE PINION COMPANION FLANGE REAR SUB-ASSEMBLY
|
(a) Using SST, remove the companion flange. SST: 09950-30012 09951-03010 09953-03010 09954-03010 09955-03030 09956-03040 |
5. REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL
|
(a) Using SST, remove the oil seal. SST: 09308-10010 |
6. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER
7. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING
|
(a) Using SST, remove the front bearing (inner race) from the drive pinion. SST: 09556-22010 |
|
(b) Using SST, remove the front bearing (outer race) from the drive pinion. SST: 09308-00010 |
8. REPLACE REAR DIFFERENTIAL DRIVE PINION BEARING SPACER
|
(a) Replace the bearing spacer with a new one. |
9. INSTALL REAR DRIVE PINION FRONT TAPERED ROLLER BEARING
|
(a) Using SST and a hammer, tap in the bearing (outer race). SST: 09316-60011 09316-00011 09316-00021 |
(b) Install the bearing (inner race).
10. INSTALL REAR DIFFERENTIAL DRIVE PINION OIL SLINGER
11. INSTALL REAR DIFFERENTIAL CARRIER OIL SEAL
|
(a) Using SST and a hammer, tap in a new oil seal. SST: 09214-76011 Standard oil seal depth: 0.05 to 0.95 mm (0.00197 to 0.0374 in.) |
(b) Coat the lip of the oil seal with MP grease.
12. INSTALL REAR DRIVE PINION COMPANION FLANGE REAR SUB-ASSEMBLY
|
(a) Using SST, install the companion flange on the drive pinion. SST: 09950-30012 09951-03010 09953-03010 09954-03010 09955-03030 09956-03040 |
13. ADJUST DRIVE PINION PRELOAD
(a) Coat the threads of a new nut with hypoid gear oil.
|
(b) Using SST to hold the companion flange, install the nut by tightening it until the standard preload is reached. SST: 09330-00021 09330-00030 Torque: 441 N·m (4497 kgf·cm, 325 ft·lbf) |
|
(c) Using a torque wrench, measure the preload. Standard Preload (at Starting):
If the preload is not within the specification, adjust the preload. |
14. STAKE DRIVE PINION COMPANION FLANGE REAR NUT
|
(a) Using a chisel and hammer, stake the nut. |
15. CONNECT PROPELLER SHAFT ASSEMBLY
16. ADD DIFFERENTIAL OIL
|
|