Home › Engine/Hybrid System › Engine Control › 3UR-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR
Last Modified: 11-27-2007 1.6 A
Service Category: Engine/Hybrid System Section: Engine Control
Model Year: 2008 Model: LX570 Doc ID: RM0000031Y5004X
Title: 3UR-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL VVT SENSOR

(a) Install the 4 sensors with the 4 bolts.

Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)

(b) Connect the 4 sensor connectors.

2. INSTALL CAMSHAFT POSITION SENSOR



(a) Install the sensor with the bolt.

Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)

(b) Connect the sensor connector.

3. INSTALL AIR CLEANER HOSE ASSEMBLY 3UR-FE INTAKE / EXHAUST: INTAKE MANIFOLD: INSTALLATION (2008 LX570)+

4. INSTALL V-BANK COVER SUB-ASSEMBLY 3UR-FE ENGINE MECHANICAL: ENGINE ASSEMBLY: INSTALLATION (2008 LX570)+

5. INSTALL UPPER RADIATOR SUPPORT SEAL EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+

6. INSTALL ENGINE ROOM SIDE COVER RH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+

7. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+