| Last Modified: 11-27-2007 | 1.6 T | |
| Service Category: Drivetrain | Section: Transfer/4wd/Awd | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000038UD001X |
| Title: JF2A TRANSFER / 4WD / AWD: TRANSFER SYSTEM: PROBLEM SYMPTOMS TABLE (2008 LX570) | ||
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Transfer System
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Noise |
Oil (Level low) |
|
|
Oil (Wrong) |
|
|
|
Transfer faulty |
|
|
|
Oil leakage |
Oil (Level too high) |
|
|
Gasket (Damaged) |
|
|
|
Oil seal (Worn or damaged) |
|
|
|
O-ring (Worn or damaged) |
|
|
|
Switch from High to Low impossible |
Harness or connector |
|
|
Transfer shift actuator |
|
|
|
CAN communication system |
|
|
|
Transfer position switch (built into integration control and panel) |
|
|
|
Four wheel drive control ECU |
|
|
|
Transfer faulty |
|
|
|
Switch from Free to Lock impossible |
Harness or connector |
|
|
Transfer shift actuator |
|
|
|
CAN communication system |
|
|
|
Center differential lock switch |
|
|
|
Four wheel drive control ECU |
|
|
|
Transfer faulty |
|
|
|
Does not switch to neutral |
CAN communication system |
|
|
Four wheel drive control ECU |
|
|
|
Transfer position switch (built into integration control and panel) |
|
|
|
Transfer shift actuator |
|
|
|
Transfer faulty |
|
|
|