|
Last Modified: 11-27-2007 |
1.6 A |
|
Service Category: Vehicle Interior |
Section: Seat |
|
Model Year: 2008 |
Model: LX570 |
Doc ID: RM00000394S002X |
|
Title: SEAT: LUMBAR SUPPORT ADJUSTER ASSEMBLY: INSTALLATION (2008 LX570) |
INSTALLATION
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH
|
(a) Install the lumbar support adjuster with the 2 screws.
|
(b) Connect the lumbar support adjuster connector.
|
(c) Attach the 4 hooks to install the seatback spring.
|
(d) Install the 4 springs.
2. INSTALL SEAT CLIMATE CONTROL CONTROLLER (w/ Climate Control Seat System)
3. INSTALL SEATBACK COVER WITH PAD
(a) Install the seatback cover with pad to the seatback frame.
|
(b) Install the seatback cover bracket to the seat frame with the nut.
Torque: 5.0 N·m (51 kgf·cm, 44 in·lbf)
CAUTION:
After the seatback cover is assembled, make sure the side airbag strap is not twisted.
|
|
(c) Attach the 9 hooks.
|
(d) Using hog ring pliers, install 3 new hog rings to the seat frame.
|
(e) w/o Climate Control Seat System:
Connect the seat heater connector and attach the 2 wire harness clamps.
|
(f) w/ Climate Control Seat System:
|
(1) Attach the 2 claws to connect the duct.
|
|
(2) Connect the seat heater connector and attach the 3 wire harness clamps.
|
4. INSTALL FRONT SEAT HEADREST SUPPORT
5. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH
6. INSTALL FRONT INNER SEAT CUSHION SHIELD LH
7. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
8. INSTALL FRONT SEAT CUSHION SHIELD LH
9. INSTALL RECLINING POWER SEAT SWITCH KNOB
10. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
11. INSTALL FRONT SEAT ASSEMBLY LH
(a) Install the front seat assembly
.
12. INSTALL ENGINE ROOM SIDE COVER LH
|