| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Door/Hatch | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039HB005X |
| Title: DOOR / HATCH: POWER BACK DOOR DRIVE UNIT: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE ENGINE ROOM SIDE COVER LH
2. REMOVE REAR SEAT CUSHION HINGE COVER RH
3. REMOVE REAR NO. 2 SEAT HINGE COVER RH
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
5. REMOVE REAR NO. 2 SEAT
(a) w/ Automatic Folding-up Function:
(1) Remove the rear No. 2 seat assembly RH
.
HINT:
Use the same procedures described for the LH side.
(b) w/ Manual Folding-up Function:
(1) Remove the rear No. 2 seat assembly RH
.
HINT:
Use the same procedures described for the LH side.
6. REMOVE REAR STEP COVER
7. REMOVE REAR DOOR SCUFF PLATE RH
8. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
9. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
10. REMOVE REAR SEAT COVER CAP (for Rear No. 2 Seat with Manual Folding-up Function)
11. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
12. REMOVE CENTER BACK DOOR GARNISH
13. REMOVE BACK DOOR SIDE GARNISH RH
14. REMOVE BACK DOOR SERVICE HOLE COVER RH
15. REMOVE REAR UPPER PILLAR GARNISH RH
16. REMOVE POWER BACK DOOR UNIT ASSEMBLY
(a) Disconnect the connector
|
(b) Remove the 4 bolts. |
(c) Detach the 2 claws and remove the power back door unit.
|
|