| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Audio/Visual/Telematics | Section: Audio/Video | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039P0001X |
| Title: NETWORKING: NETWORK GATEWAY ECU: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
3. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
4. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH
5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
6. REMOVE FRONT DOOR SCUFF PLATE RH
7. REMOVE COWL SIDE TRIM BOARD RH
8. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
9. REMOVE INSTRUMENT PANEL BOX DOOR KNOB
10. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
11. REMOVE NETWORK GATEWAY ECU
(a) Disconnect the connector.
(b) Remove the nut and ECU.
|
|