| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Suspension | Section: Suspension Control System | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039ZT001X |
| Title: SUSPENSION CONTROL: HEIGHT CONTROL ACCUMULATOR: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL SUSPENSION CONTROL PUMP ACCUMULATOR ASSEMBLY
(a) Install the accumulator with the 3 nuts.
Torque: 31 N·m (316 kgf·cm, 23 ft·lbf)
2. INSTALL NO. 7 HEIGHT CONTROL TUBE
(a) Using a union nut wrench, install the No. 7 control tube to the control valve and accumulator.
Torque: 15 N·m (155 kgf·cm, 11 ft·lbf)
Torque: 14 N·m (143 kgf·cm, 10 ft·lbf)
HINT:
- Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
- The torque value for use with a union nut wrench is effective when the union nut wrench is parallel to the torque wrench.
3. INSTALL CENTER EXHAUST PIPE ASSEMBLY
4. INSTALL TAILPIPE ASSEMBLY
5. BLEED AIR FROM SUSPENSION FLUID
6. CHECK FLUID LEVEL IN RESERVOIR
7. INSPECT FOR SUSPENSION FLUID LEAK
8. INSTALL HEIGHT CONTROL UNIT INSULATOR
9. CHECK FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
|
|