Home › Suspension › Suspension Control System › SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front Side)
Last Modified: 11-27-2007 1.6 A
Service Category: Suspension Section: Suspension Control System
Model Year: 2008 Model: LX570 Doc ID: RM000003A07001X
Title: SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front Side): INSTALLATION (2008 LX570)

INSTALLATION

HINT:

1. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

(a) Install the sensor with the bolt and nut.

Torque: 13 N·m (127 kgf·cm, 9 ft·lbf)

Torque: 5.6 N·m (57 kgf·cm, 50 in·lbf)

(b) Connect the connector.

2. INSTALL FRONT WHEEL

Torque: 131 N·m (1336 kgf·cm, 97 ft·lbf)

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

4. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION

(a) Perform the vehicle height offset calibration SUSPENSION CONTROL: ACTIVE HEIGHT CONTROL SUSPENSION: INITIALIZATION (2008 LX570) .

5. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front Side): ADJUSTMENT (2008 LX570)+

6. INSTALL FRONT FENDER APRON SEAL FRONT LH 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 LX570)+

7. PERFORM ZERO POINT CALIBRATION OF G SENSOR

(a) Perform the zero point calibration of the G sensor BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: CALIBRATION (2008 LX570) .

8. ADJUST HEADLIGHT ASSEMBLY

(a) Adjust the headlight LIGHTING (EXT): HEADLIGHT ASSEMBLY: ADJUSTMENT (2008 LX570) .