Home › Suspension › Suspension Control System › SUSPENSION CONTROL: SUSPENSION CONTROL ECU
Last Modified: 11-27-2007 1.6 A
Service Category: Suspension Section: Suspension Control System
Model Year: 2008 Model: LX570 Doc ID: RM000003A0B001X
Title: SUSPENSION CONTROL: SUSPENSION CONTROL ECU: INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL SUSPENSION CONTROL ECU

(a) Attach the wire harness clamp and connect the connector.

(b) Install the ECU with the 2 bolts.

Torque: 8.0 N·m (82 kgf·cm, 71 in·lbf)

2. INSTALL REAR SIDE NO. 2 AIR DUCT HEATING / AIR CONDITIONING: REAR AIR CONDITIONING UNIT: REASSEMBLY (2008 LX570)+

3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

4. INSTALL REAR SEAT COVER CAP (for Semi Power Seat) INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

6. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

7. INSTALL REAR DOOR SCUFF PLATE LH INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

8. INSTALL REAR STEP COVER INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

9. INSTALL REAR NO. 2 SEAT ASSEMBLY LH

(a) w/ Manual Folding-up Function:

Install the rear No. 2 seat assembly LH SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Manual Folding-up Function): INSTALLATION (2008 LX570) .

(b) w/ Automatic Folding-up Function:

Install the rear No. 2 seat assembly LH SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): INSTALLATION (2008 LX570) .

10. INSTALL REAR NO. 2 SEAT ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

12. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION

(a) Perform the vehicle height offset calibration SUSPENSION CONTROL: ACTIVE HEIGHT CONTROL SUSPENSION: INITIALIZATION (2008 LX570) .

13. PERFORM ZERO POINT CALIBRATION OF G SENSOR

(a) Perform the zero point calibration of the G sensor BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: CALIBRATION (2008 LX570) .

14. ADJUST HEADLIGHT ASSEMBLY

(a) Adjust the headlight LIGHTING (EXT): HEADLIGHT ASSEMBLY: ADJUSTMENT (2008 LX570) .