|
Last Modified: 11-27-2007 |
1.6 A |
|
Service Category: Suspension |
Section: Suspension Control System |
|
Model Year: 2008 |
Model: LX570 |
Doc ID: RM000003A0D001X |
|
Title: SUSPENSION CONTROL: SUSPENSION CONTROL ECU: REMOVAL (2008 LX570) |
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
2. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
(a) w/ Manual Folding-up Function:
Remove the rear No. 2 seat assembly LH
.
(b) w/ Automatic Folding-up Function:
Remove the rear No. 2 seat assembly LH
.
3. REMOVE REAR NO. 2 SEAT ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
4. REMOVE REAR STEP COVER
5. REMOVE REAR DOOR SCUFF PLATE LH
6. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
7. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
8. REMOVE REAR SEAT COVER CAP (for Semi Power Seat)
9. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
10. REMOVE REAR SIDE NO. 2 AIR DUCT
11. REMOVE SUSPENSION CONTROL ECU
|
(a) Remove the 2 bolts and ECU.
|
(b) Detach the wire harness clamp and disconnect the connector.
|