RX400h · Service Manual BODY

DISASSEMBLY

Removal / installation


1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

  1. B110462
    Disengage the claw and remove the sliding roof drive gear bracket.

  1. B110476
    Remove the 2 bolts and sliding roof drive gear sub-assembly.


2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

  1. Remove the 2 screws and sliding roof LH and RH piece sub-assemblies.

  1. Slide and remove the sunshade trim sub-assembly.


3. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:
Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.

  1. Remove the 2 screws and sliding roof guide stoppers.

  1. B110469E01
    Using a screwdriver, disengage the 2 claws. Then slide the sliding roof drip channel rearward to remove it.

    HINT:
    Tape the screwdriver tip before use.

  1. B110470
    Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

    HINT:
    Tape the screwdriver tip before use.

← REMOVALREASSEMBLY →