INSPECTION

1. Secure the rear stabilizer link assembly in a vise using aluminum plates.
   

2. Install the nut to the rear stabilizer link assembly stud.
   

3. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.
   

   Turning torque:

   1.0 N*m (10 kgf*cm, 8.9 in.*lbf) or less
   

   HINT:

   If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.

Inspect the dust cover.

1. Check that the dust cover is not cracked and that there is no grease on it.