ADJUSTMENT
Removal / installation
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. INSPECT BACK DOOR |
Check that the clearance is within the standard range.
Standard range: A
6.5 +- 2.0 mm (0.256 +- 0.078 in.)
B
8.1 +- 2.0 mm (0.319 +- 0.078 in.)
C
1.0 +- 2.0 mm (0.039 +- 0.078 in.)
D
5.5 +- 1.5 mm (0.217 +- 0.059 in.)
E
0 +- 1.5 mm (0 +- 0.059 in.)
| 3. ADJUST BACK DOOR |
Loosen the body side hinge nuts and adjust the door right, left, forward, and rearward.
- Torque:
- 19.5 N*m{ 199 kgf*cm , 14 ft.*lbf }
Horizontally and vertically adjust the back door by loosening the back door side hinge bolts.
- Torque:
- 19.5 N*m{ 199 kgf*cm , 14 ft.*lbf }
When adjusting the back door rear side to side and the back door lock striker assembly, loosen the bolts until the striker can move. Lightly tap striker with a brass bar for adjustment.
- Torque:
- 23 N*m{ 235 kgf*cm , 17 ft.*lbf }
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. PERFORM INITIALIZATION |