RX400h · Service Manual BRAKE

INSPECTION

Inspection


INSPECT FRONT SPEED SENSOR

  1. Inspect the front speed sensor. If any of the following occurs, replace the front speed sensor with a new one:

    1. The surface of the front speed sensor is cracked, dented, or chipped off.
    2. The connector is scratched, cracked, or damaged.
    3. The front speed sensor has been dropped.

  1. F100406E01
    Measure the resistance according to the value(s) in the table below.

    Resistance:
    LH 
    Tester Connection
    		 Specified Condition
    2 (FL+) - 1 (FL-)
    		 1.4 to 1.8 kΩ
    RH 
    Tester Connection
    		 Specified Condition
    2 (FR+) - 1 (FR-)
    		 1.4 to 1.8 kΩ

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    LH 
    Tester Connection
    		 Specified Condition
    1 (FL-) - Body ground
    		 10 kΩ or higher
    2 (FL+) - Body ground
    		 10 kΩ or higher
    RH 
    Tester Connection
    		 Specified Condition
    1 (FR-) - Body ground
    		 10 kΩ or higher
    2 (FR+) - Body ground
    		 10 kΩ or higher

← REMOVALINSTALLATION →