GENERAL MAINTENANCE

Check the steering linkage for looseness or damage.
Check that:

1. Tie rod ends do not have excessive play.
   

1. Dust seals and boots are not damaged.
   

1. Boot clamps are not loose.
   

Inspect the drive shaft boots for clamp looseness, grease leakage or damage.

1. Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.
   

2. Lower the jack until there becomes about half a load on the front coil spring. Place stands under the vehicle for safety.
   

3. Check that the front wheels are pointing straight ahead, and block them with chocks.
   

4. Using a lever, pry up the end of the lower arm, and check the amount of play.
   

   Maximum ball joint vertical play:

   0 mm (0 in.)
   

   If there is any play, replace the ball joint.
   

Visually check the transaxle for oil fluid leakage.
(Click here for Q211 transaxle)
(Click here for P310 transaxle)