ADJUSTMENTS

Pedal Free Play

1. Measure the clutch pedal height from the face of the pedal pad to the firewall. The desired distances are as follows:
   1. Mirage — 6.61–6.8 in. (168–171mm)
   2. Galant — 6.93–7.17 in. (176–182mm)
2. Measure the clutch pedal clevis pin play at the face of the pedal pad. The standard values are as follows:
   1. Mirage — 0.04–0.12 in. (1–3mm)
   2. Galant — 0.04–0.12 in. (1–3mm)
3. If the clutch pedal height or clevis pin play are not within the standard values, adjust as follows:
   1. For vehicles without cruise control, turn and adjust the bolt so the pedal height is the standard value, then tighten the locknut.
   2. For vehicles with the auto-cruise control system, detach the clutch switch connector and turn the switch to obtain the standard clutch pedal height. Then, lock with the locknut.
   3. Turn the pushrod to adjust the clutch pedal clevis pin play to agree with the standard value and secure the pushrod with the locknut.

      NOTE: When adjusting the clutch pedal height or the clutch pedal clevis pin play, be careful not to push the pushrod toward the master cylinder.

   4. Check that when the clutch pedal is depressed all the way, the interlock switch switches over from ON to OFF.