[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
23 -AUTOMATIC TRANSMISSION > 23A-CVT > TROUBLESHOOTING<S-AWC><S-AWC> > DIAGNOSIS CODE PROCEDURES > CODE NO. C2205 STEERING WHEEL SENSOR SYSTEM (INTERNAL ERROR)
Code No. C2205: Steering Wheel Sensor System (Internal Error)
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
  • When the steering wheel sensor is replaced, calibrate the steering wheel sensor (Refer to GROUP 35C - On-vehicle Service ), and reset the steering wheel sensor correction amount stored in the AWC-ECU (Item No. 1: Steering angle adjusted value ).
 
 
OPERATION
AWC-ECU communicates with the steering wheel sensor via the CAN bus lines.
 
 
DIAGNOSIS CODE SET CONDITIONS
This diagnosis code is set when the AWC-ECU receives the failure status information by the self-diagnosis of the steering wheel sensor.
 
 
PROBABLE CAUSES
  • Malfunction of the steering wheel sensor
  • Malfunction of AWC-ECU

 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
Use M.U.T.-IIISE to perform the CAN bus diagnosis.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE data list.
Check the following data list (Refer to ).
Item No.21: Steering angle
Is the check result normal?
Go to Step 3.
Replace the steering wheel sensor (Refer to GROUP 35C - Steering Wheel Sensor ).
 
STEP 3. Check whether the diagnosis code is set again.
Is diagnosis code No.C2205 set?
Replace the AWC-ECU (Refer to ).
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).