[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
32 -POWER PLANT MOUNT > TRANSMISSION MOUNTING > TRANSMISSION MOUNTING REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
Pre-removal and post-installation operation
  • Engine Room Under Cover Front A, B and Engine Room Side Cover (LH) Removal and Installation (Refer to GROUP 51 - Under Cover ).
  • Battery and Battery Tray Removal and Installation (Refer to GROUP 54A - Battery ).
  • Air Cleaner Assembly Removal and Installation (Refer to GROUP 15 - Air Cleaner ).
  • Engine-ECU Removal and Installation (Refer to GROUP 13A - Engine-ECU ).
 
Removal
<<A>>>>A<<1.Transmission mounting bracket
 
 
REMOVAL SERVICE POINT
 
 
<<A>> TRANSMISSION MOUNTING BRACKET REMOVAL
1. Place a garage jack against the transmission case with a piece of wood in between to support the engine and transmission assembly.
2. Operate a garage jack so that the transmission weight is not applied to the transmission mounting bracket, and remove the transmission mounting bracket.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< TRANSMISSION MOUNTING BRACKET INSTALLATION
cautionDo not remove small tapping screw on the back side.
 
Tighten the transmission mounting bracket mounting bolts by the following procedure.
 
OrderBoltTightening torque
1stAApproximately 0 - 5.0 N·m
2ndB50 ± 5 N·m
3rdA50 ± 5 N·m