2018 / ECLIPSE CROSS / EC - Workshop Manual
36 -PARKING BRAKE > TROUBLESHOOTING<ELECTRIC PARKING BRAKE><ELECTRIC PARKING BRAKE> > DIAGNOSIS CODE PROCEDURES > CODE NO. U1195 CODING NOT COMPLETED
Code No. U1195: Coding not completed
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
  • When the diagnosis code U1195 is set in electric parking brake ECU, the diagnosis code may also be set in ETACS-ECU. When the diagnosis code is set in ETACS-ECU, carry out the diagnosis of the diagnosis code for ETACS-ECU first.
 
 
DIAGNOSIS CODE SET CONDITIONS
When the electric parking brake ECU does not store any vehicle information data sent by the ETACS-ECU, the diagnosis code will be set.
 
 
PROBABLE CAUSES
  • The CAN bus line is defective.
  • Variant coding for ETACS-ECU has not been implemented.
  • Malfunction of the ETACS-ECU
  • Malfunction of the electric parking brake ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnosis
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
 
STEP 2. Use M.U.T.-IIISE to confirm a diagnosis code of other systems.
Check if the diagnosis code is set in the ETACS-ECU (Refer to GROUP 54A - ETACS, Diagnosis Code Chart ).
Is the diagnosis code set?
Troubleshoot the ETACS-ECU diagnosis code (Refer to GROUP 54A - ETACS, Diagnosis Code Chart ).
Go to Step 3.
 
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set.
(1) Turn the ignition switch to the LOCK (OFF) position.
(2) Turn the ignition switch to the ON position.
(3) Check if the diagnosis code is set.
Is diagnosis code No. U1195 set?
Replace the electric parking brake ECU (Refer to ).
This diagnosis is complete.