[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
42 -BODY > 42A-BODY > POWER PANORAMIC SUNROOF > SUNROOF ASSEMBLY > SUNROOF ASSEMBLY REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
Post-installation operation
  • Roof rack (Refer to GROUP 51, Roof Rack ).
  • Sunroof leakage check (Refer to ).
  • Sunroof alignment (Refer to ).
  • Learning procedures for sunroof fully closed position (Refer to ).
 
 
Roof side fin assembly/Side fin clip assembly removal
1.Roof side fin assembly
2.Side fin clip assembly
Slide glass panel assembly/Slide weatherstrip removal steps
•Headlining (Refer to GROUP 52A, Headlining )
1.Roof side fin assembly
2.Side fin clip assembly
3.Slide glass panel assembly
4.Slide weatherstrip
Deflector assembly/Deflector fastener/Front fix weatherstrip removal steps
•Headlining (Refer to GROUP 52A, Headlining )
1.Roof side fin assembly
2.Side fin clip assembly
3.Slide glass panel assembly
4.Slide weatherstrip
5.Deflector assembly
6.Deflector fastener
7.Front fix weatherstrip
Mechanism assembly removal
•Headlining (Refer to GROUP 52A, Headlining )
1.Roof side fin assembly
2.Side fin clip assembly
>>A<<8.Centre pillar bracket
9.Clip centre reinforce assembly
10.Clip bracket assembly
11.Mechanism assembly

 
 
INSTALLATION SERVICE POINT
 
 
>>A<< CENTRE PILLAR BRACKET INSTALLATION
 
1. Temporarily fix the centre pillar bracket with the bolt (1) shown in the figure.
2. Tighten the roof side bolts (2) first, and then tighten the pillar side bolts (3).