[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
42 -BODY > 42B-KEYLESS OPERATION SYSTEM (KOS) > TROUBLESHOOTING > DIAGNOSIS CODE PROCEDURES > B1731 Engine ECU communication timeout
Code No. B1731 ENG ECU authentification timeout
 
 
caution
  • When diagnosis code No. B1731 is set, be sure to diagnose the CAN bus line.
  • When replacing the ECU, always check that the communication circuit is normal.
 
 
DIAGNOSTIC FUNCTION
If the necessary data cannot be received from engine-ECU via CAN bus line during the engine starting certification with engine-ECU, KOS&OSS-ECU determines that a problem has occurred, and sets diagnosis code No.B1731. At the same time, KOS&OSS-ECU displays the immobilizer certification system inspection warning to the combination meter.
 
 
JUDGEMENT CRITERIA
Check Conditions
  • At engine starting certification
Judgement Criterion
  • At the engine starting certification with engine-ECU, necessary data cannot be received from engine-ECU via CAN bus line.
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • Malfunction of engine-ECU
  • Malfunction of KOS&OSS-ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE other system diagnosis code
(1) Check that the vehicle power can be turned ON and engine is started.
(2) Check the diagnosis code of engine-ECU.
Is the diagnosis code set?
Troubleshoot the engine-ECU (Refer to GROUP 13A - Troubleshooting ). Then go to Step 3.
Go to Step 3.
 
STEP 3. Check whether the diagnosis code is set again.
(1) Operate the engine switch several times within five seconds without depressing the brake pedal to turn ON and OFF the power supply mode.
(2) Check again if the diagnosis code is set in the KOS&OSS-ECU.
Is the diagnosis code set?
Replace the KOS&OSS-ECU and register the ID codes (Refer to ). Then go to Step 4.
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 4. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the KOS&OSS-ECU.
Is the diagnosis code set?
Replace the engine-ECU (Refer to GROUP 13A - Engine-ECU ).
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).