[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
42 -BODY > 42B-KEYLESS OPERATION SYSTEM (KOS) > TROUBLESHOOTING > DIAGNOSIS CODE PROCEDURES > U1195 Coding not completed
Code No. U1195 Coding not completed
 
 
caution
  • If diagnosis code No. U1195 is set, diagnose the CAN bus lines.
  • When replacing the ECU, always check that the communication circuit is normal.
 
 
DIAGNOSTIC FUNCTION
When the coding data is not registered, KOS&OSS-ECU sets diagnosis code No.U1195.
noteWhen KOS&OSS-ECU is new, diagnosis codes No.U1195 are set simultaneously.
 
 
JUDGEMENT CRITERIA
Check Conditions
  • When all the following conditions are met.
    1. Coding is not completed.
    2. For 5 seconds since the start of the reception of ignition status signal (ON or during cranking) transmitted from ETACS-ECU.
Judgement Criterion
  • Any of the coding is not completed normally.
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • Variant coding for ETACS-ECU has not been implemented.
  • Malfunction of KOS&OSS-ECU
  • ETACS-ECU malfunction
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE other system diagnosis code
Check again if the diagnosis code is set in the ETACS-ECU.
Is the diagnosis code set?
Diagnose the ETACS-ECU (Refer to GROUP 54A - ETACS - Troubleshooting ).
Go to Step 3.
 
STEP 3. Diagnosis code recheck
Check again if the diagnosis code is set in the KOS&OSS-ECU.
(1) Erase the diagnosis code.
(2) Turn the power supply mode of the engine switch from "OFF" to "ON".
(3) Check if the diagnosis code is set.
Is the diagnosis code set?
Replace the KOS&OSS-ECU and register the ID codes (Refer to ).
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to cope with Intermittent Malfunction ).