[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > ULTRASONIC MISACCELERATION MITIGATION SYSTEM/CORNER SENSOR SYSTEM > DIAGNOSIS CODE PROCEDURES > CODE No. U0121 ABS/ASC-ECU TIMEOUT
Code No.U0121 ABS/ASC CAN timeout
 
 
caution
  • If diagnosis code No. U0121 is set, be sure to diagnose the CAN bus line.
  • When replacing the ECU, always check that the communication circuit is normal.
 
 
OPERATION
The clearance warning control unit sets diagnosis code No.U0121 when it cannot receive signals from the ASC-ECU.
 
 
TROUBLE JUDGEMENT
If the communication with ASC-ECU cannot be established for 2,500 ms or more.
 
 
PROBABLE CAUSES
  • Malfunction of CAN bas line
  • Malfunction of ASC-ECU power supply circuit
  • Malfunction of ASC-ECU
  • Malfunction of clearance warning control unit
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. Check the M.U.T.-IIISE Diagnosis code for other system.
Check if diagnosis code No. U0121 is set in the ETACS-ECU.
Is the diagnosis code set?
Go to Step 3.
Go to Step 4.
 
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the clearance warning control unit.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the diagnosis code is set.
Is the diagnosis code set?
Replace the ASC-ECU (Refer to GROUP 35C - Hydraulic unit ).
A poor connection, open circuit, or other intermittent malfunction in the CAN bus line between the clearance warning control unit and the ASC-ECU (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 4. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the clearance warning control unit.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the diagnosis code is set.
Is the diagnosis code set?
Replace the clearance warning control unit (Refer to ).
A poor connection, open circuit, or other intermittent malfunction in the CAN bus line between the clearance warning control unit and the ASC-ECU (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).