[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > ULTRASONIC MISACCELERATION MITIGATION SYSTEM/CORNER SENSOR SYSTEM > SYMPTOM PROCEDURES > The system cannot be activated or deactivated when you operate the sonar switch.
Inspection Procedure 3: The system cannot be activated or deactivated when you operate the sonar switch.
 
 
 
 
COMMENTS ON TROUBLE SYMPTOM
When the system cannot be activated or deactivated by operating the sonar switch, the sonar switch or the clearance warning control unit may have a problem.
noteDiagnosis code C2225 may be set.
 
 
PROBABLE CAUSES
  • Malfunction of sonar switch
  • Malfunction of clearance warning control unit
  • Damaged harness wires and connectors
 
 
DIAGNOSIS PROCEDURE
STEP 1. Check of short to earth, and open circuit in CSW line between the clearance warning control unit connector and sonar switch connector.
Is the check result normal?
Go to Step 2.
Repair the connector(s) or wiring harness.
 
STEP 2. Check of open circuit in earth line between the sonar switch connector and body earth.
Is the check result normal?
Go to Step 3.
Repair the connector(s) or wiring harness.
 
STEP 3. Check the sonar switch.
Refer to .
Is the check result normal?
Go to Step 4.
Replace the sonar switch (Refer to ).
 
STEP 4. M.U.T.-IIISE data list.
Check the input signal (Refer to ).
  • Operate the sonar switch.
 
Item No.Item nameNormal condition
77Corner sensor SW input signalWhen the switch is operated: ON
When the switch is not operated: OFF
OK: Normal condition is displayed.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace the clearance warning control unit (Refer to ).