[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > FCM/LDW/AHB-ECU > DIAGNOSIS CODE PROCEDURES > CODE NO. U1195 CODING NOT COMPLETED
Code No. U1195 Coding not completed
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the communication circuit is normal.
 
 
OPERATION
FCM/LDW/AHB-ECU receives the vehicle information stored in ETACS-ECU via CAN bus lines.
 
 
DIAGNOSIS CODE SET CONDITION
This diagnosis code is set when the abnormality below is detected:
  • Coding has not been performed.
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • Coding not implemented
  • Malfunction of the ETACS-ECU
  • Malfunction of the FCM/LDW/AHB-ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
Use M.U.T.-IIISE to perform the CAN bus diagnosis.
Is the check result normal?
Go to Step 2
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. Check the M.U.T.-IIISE other system diagnosis code.
Check the ETACS-ECU diagnosis code.
Is the diagnosis code set?
Troubleshoot the relevant diagnosis code (Refer to ).
Go to Step 3
 
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the FCM/LDW/AHB-ECU.
(1) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(2) Hold the ignition switch ON for five seconds.
(3) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(4) Check if diagnosis code is set.
Is the diagnosis code set?
Replace the FCM/LDW/AHB-ECU (Refer to ).
This diagnosis is complete.