The ignition switch is mounted in place using special shear bolts. Removal
of the ignition switch requires replacement of these bolts. When removing the
bolts it is easiest if you use a suitable punch and hammer to tap the bolts
around. When installing new bolts tighten the bolts until the shear heads break
off.
- Disconnect the negative battery cable.
- Remove the upper and lower steering column covers. On some models the steering
wheel may need to be removed.
- Some models the hazard warning knob may need removal.
- Disconnect the ignition switch harness from the body harness.
- Using a drift and hammer, hit the heads of the shear bolts to loosen and
remove the ignition switch mounting bolts.
- Install the ignition switch with new mounting bolts. Tighten the mounting
bolts until the bolt heads snap off. Install all remaining components and
secure.
