Ignition Timing

ADJUSTMENT

The ignition timing is controlled by the engine control computer and is not adjustable. To check the ignition timing proceed as follows:

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Warm up the engine, then turn the ignition OFF.
3. Connect a timing light to the No. 1 spark plug wire according to the manufactures directions.
4. Start the engine. With the vehicle at idle check the timing.
5. The timing should be 7-23 degrees BTDC at 700 RPM.
6. If the timing is not correct, there could be a problem in the ignition control system.