Crankshaft Damper

Removal & Installation

To Remove:

1. Remove the following
   • V-belt

     Crank Pulley

   • Crankshaft pulley bolt

     NOTE: To lock the crankshaft, use ST. ST 499977100 CRANKSHAFT PULLEY WRENCH.

   • Crankshaft pulley

To Install:

1. Install the following
   • Crankshaft pulley
   • Pulley bolt

   NOTE: To lock the crankshaft, use ST. ST 499977100 Crankshaft Pulley Wrench.

2. Clean the crankshaft pulley thread using an air gun
3. Apply engine oil to the crankshaft pulley bolt seat and thread
4. Tighten the bolts temporarily
   • Torque specification 44 Nm (33 ft. lbs.)
5. Tighten the crankshaft pulley bolts
6. Confirm that the tightening angle of crankshaft pulley bolt is 65 degrees or more, if not, the bolt must be replaced
7. Tighten the crankshaft pulley bolts keeping them in an angle between 65 and 75 degrees

   NOTE: Conduct the tightening procedures by confirming the turning angle of crankshaft pulley bolt referring to the gauge indicated on timing belt cover.

   • A/C belt tensioner
   • V-belt