Testing

1. Confirm that the engine does not start when the clutch pedal is released and if the engine starts, adjust the clutch switch and inspect the starter interlock circuit
2. Confirm that the engine starts when the clutch pedal is fully depressed. If the engine does not start, adjust the clutch switch and inspect the starter interlock circuit
3. Disconnect the clutch switch connector and check the resistance between terminals 1 and 2 of switch side of connection, if continuity is not as specified, replace the switch
   • Resistance specification: When clutch pedal is depressed, less than 1 Ohm; When clutch pedal not depressed, more than 1 M Ohm