DTC P0706 / P0707 / P0708
Precautions: Precautions for Diagnosing Trouble · Precautions for Disassembly and Reassembly · Precautions for Transmission / Transaxle · General safety (00)
DTC Detecting Condition and Trouble Area
| DTC detecting condition | Trouble area |
|---|---|
|
P0706: Transmission Range Sensor “A” Circuit Range / Performance Faulty information is received from transmission range sensor. (Transmission range sensor is stuck.) (1 D/C detection logic) |
TCM |
|
P0707: Transmission Range Sensor “A” Circuit Low Transmission range sensor signal circuit voltage is lower than specified value. (1 D/C detection logic) |
|
|
P0708: Transmission Range Sensor “A” Circuit High Transmission range sensor signal circuit voltage is higher than specified value. (1 D/C detection logic) |
DTC Confirmation Procedure
NOTE:
Check that the following condition is met in this “DTC Confirmation Procedure”.
•DTC U0073 or U0100 is not detected.
1)Set ignition “ON”.
2)Shift select lever from P to M range.
DTC Troubleshooting
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
Was “A/T Control System Check” performed?
|
Go to Step 2.
|
Go to A/T Control System Check.
|
| 2 |
DTC check
1)Clear DTC.
2)Set ignition “OFF”.
3)Perform “DTC Confirmation Procedure”, and check DTC.
Is DTC P0706, P0707 or P0708 still indicated?
|
Substitute a known-good TCM and recheck DTC.
|
Check for intermittent trouble.
|