DTC P0711 / P0712 / P0713

Precautions: Precautions for Diagnosing Trouble · Precautions for Disassembly and Reassembly · Precautions for Transmission / Transaxle · General safety (00)

DTC Detecting Condition and Trouble Area

DTC detecting condition	Trouble area
P0711: Transmission Fluid Temperature Sensor “A” Circuit Range / Performance ATF temperature sensor signal circuit voltage is unchanged for 10 minutes during driving. (2 D/C detection logic)	•Solenoid harness with ATF temperature sensor •TCM
P0712: Transmission Fluid Temperature Sensor “A” Circuit Low ATF temperature sensor signal circuit voltage is lower than specified value for 5 sec. (2 D/C detection logic)
P0713: Transmission Fluid Temperature Sensor “A” Circuit High ATF temperature sensor signal circuit voltage is higher than specified value for 5 sec. after driving. (2 D/C detection logic)

DTC Confirmation Procedure

P0711 / P0713

WARNING:

If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.

•Select a level road with no traffic to minimize the risk of accident.
•Perform the test extremely carefully.
•Perform the road test using 2 persons, a driver and a tester.

1)Warm up engine to normal operating temperature.

2)Drive vehicle for 10 minutes or more.

P0712

1)Set ignition “ON” for 10 sec.

DTC Troubleshooting

Step	Action	Yes	No
1	Was “A/T Control System Check” performed?	Go to Step 2.	Go to A/T Control System Check.
2	ATF temperature sensor check 1)Check ATF temperature sensor. Is check result OK?	Substitute a known-good TCM and recheck DTC.	Replace solenoid harness with ATF temperature sensor.