DTC C1164
Precautions: Precautions for Diagnosing Trouble · Precautions for Steering · General safety (00)
DTC Detecting Condition and Trouble Area
| DTC detecting condition | Trouble area |
|---|---|
|
C1164: CAN Invalid Data from BCM Invalid data about steering assist torque request is received from BCM or steering assist torque request from BCM is received for more than 30 sec. |
•CAN communication circuit
•BCM •P/S control module (steering column assembly) |
DTC Troubleshooting
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
Was “P/S System Check” performed?
|
Go to Step 2.
|
Go to P/S System Check and recheck DTC.
|
| 2 |
DTC check
1)Check for DTC.
Is other DTC(s) than C1164 detected?
|
Go to troubleshooting for applicable DTC(s).
|
Go to Step 3.
|
| 3 |
DTC check for BCM
1)Check BCM for DTC.
Is any DTC(s) detected?
|
Go to applicable DTC troubleshooting.
|
Go to Step 4.
|
| 4 |
BCM check
1)Check that ignition is “OFF”.
2)Replace BCM.
3)Set ignition “ON”.
4)Check for DTC.
Is DTC C1164 stored?
|
Substitute a known-good steering column assembly and recheck DTC.
|
End.
|