Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the cruise control system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.PROBLEM SYMPTOM CONFIRMATION

      NEXT


      3.DTC CHECK AND CLEAR*
        Refer to the DTC CHECK / CLEAR (Click here).

      NEXT


      4.DTC CHECK (OTHER THAN MPX AND CAN SYSTEM DTC)*

        Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      A.
      GO TO STEP 6
      B


      5.DTC CHART
        Refer to the DIAGNOSTIC TROUBLE CODE CHART (Click here).

      NEXT

      GO TO STEP 9


      6.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        Proceed to
        Symptom occurs
        A
        Symptom does not occur
        B



      A.
      GO TO STEP 8
      B


      7.SYMPTOM SIMULATION

        NEXT

        Go to step 6


        8.PROBLEM SYMPTOMS TABLE
          Refer to the PROBLEM SYMPTOMS TABLE (Click here).

        NEXT


        9.CIRCUIT INSPECTION

          NEXT


          10.TERMINALS OF ECM
            Refer to TERMINALS OF ECM (Click here).

          NEXT


          11.IDENTIFICATION OF PROBLEM

            NEXT


            12.REPAIR OR REPLACE

              NEXT


              13.CONFIRMATION TEST

                NEXT

                END