Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Be sure to perform the SYMPTOM SIMULATION procedure before replacing the ECM. If these symptoms do not persist, the cause of the problem may be a poor intermittent electrical contact (open or short) of a wire harness or connector.


Cruise control system 
Symptom
Suspected area
See page
Main switch cannot be turned ON. (Cruise indicator light in combination meter is not lit.)
1. Cruise control switch circuit
Click here
2. CRUISE MAIN indicator light circuit
Click here
3. Replace ECM
Click here
4. Replace ECM
Click here
Vehicle speed setting cannot be done. (Although indicator light in combination meter is lit when the main switch is turned ON, they go off when vehicle speed is set.)
1. Cruise control switch circuit
Click here
2. Replace ECM
Click here
3. Replace ECM
Click here
Setting cannot be done. (Indicator light in combination meter is lit when the main switch is turned ON and they remain ON while setting.)
1. Cruise control switch circuit
Click here
2. Stop light switch
Click here
3. PNP switch (A750E)
Click here
4. PNP switch (A750F)
Click here
5. Combination meter system
Click here
6. Replace ECM
Click here
7. Replace ECM
Click here
While the vehicle is driving with cruise control, the set control is canceled. (Indicator light and CRUISE remain ON.)
1. Cruise control switch circuit
Click here
2. Vehicle speed sensor circuit
-
3. Stop light switch
Click here
4. CRUISE MAIN indicator light circuit
Click here
5. PNP switch (A750E)
Click here
6. PNP switch (A750F)
Click here
7. Replace ECM
Click here
8. Replace ECM
Click here
Hunting (Speed is not constant.)
1. Vehicle speed sensor circuit
-
2. Replace ECM
Click here
3. Replace ECM
Click here
Setting cannot be canceled. (When Coast, Acceleration, Resume, Set speed change and Control switch are operated.)
1. Cruise control switch circuit
Click here
2. Replace ECM
Click here
3. Replace ECM
Click here
DTC is not output, or is output when should not be.
1. TC and CG terminal circuit
Click here
2. Replace ECM
Click here
3. Replace ECM
Click here
CRUISE MAIN indicator light does not light up.
1. Cruise control switch circuit
Click here
2. CRUISE MAIN indicator light circuit
Click here
3. Replace ECM
Click here
4. Replace ECM
Click here