DTC P2610 ECM / PCM Internal Engine Off Timer Performance |
| DTC No. | Monitoring Item | Malfunction Detection Condition | Trouble Area | Detection Timing | Detection Logic |
| P2610 | Soak timer (built into ECM) | ECM internal malfunction | ECM | Engine running | 2 trip |

| Related DTCs | P2610: Soak timer (built into ECM) |
| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| Duration | 10 minutes |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTC not present | None |
| Ignition switch | ON |
| Engine | Running |
| Battery voltage | 8 V or more |
| Starter | OFF |
| Soak timer measurement when ECM CPU clock counts 10 minutes | Less than 7 minutes or more than 13 minutes |
| 1.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch ON and turn the intelligent tester ON.
Clear DTCs (Click here).
Start the engine and wait for 10 minutes or more.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC / INFO / PENDING CODES.
If no pending DTC is displayed, the repair has been successfully completed.
| NEXT | ||
| ||