Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION SYSTEM

DTC    B1796    Sleep Operation Failure of Occupant Classification ECU

for Preparation Click here


DESCRIPTION

During sleep mode, the occupant classification ECU reads the condition of each sensor while the ignition switch is off.
In this mode, if the occupant classification ECU detects an internal malfunction, DTC B1796 is output.

DTC No.
DTC Detecting Condition
Trouble Area
B1796
Occupant classification ECU malfunction
Occupant classification ECU

INSPECTION PROCEDURE

1.CHECK DTC
  1. Turn the ignition switch to the ON position.

  1. Clear the DTCs stored in memory (Click here).

    HINT:
    First clear DTCs stored in the occupant classification ECU and then in the center airbag sensor assembly.

  1. Turn the ignition switch to the LOCK position, and wait for at least 10 seconds.

  1. Turn the ignition switch to the ON position.

  1. Check the DTCs (Click here).

    OK:
    DTC B1796 is not output.

    HINT:
    Codes other than DTC B1796 may be output at this time, but they are not related to this check.



OK
USE SIMULATION METHOD TO CHECK
NG


2.REPLACE OCCUPANT CLASSIFICATION ECU
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery.

  1. Replace the occupant classification ECU (Click here).

    HINT:
    Perform the inspection using parts from a normal vehicle if possible.


NEXT


3.PERFORM ZERO POINT CALIBRATION
  1. Connect the negative (-) terminal cable to the battery.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Using the intelligent tester, perform "Zero point calibration" (Click here).

    OK:
    The "COMPLETED" is displayed.


NEXT


4.PERFORM SENSITIVITY CHECK
  1. Using the intelligent tester, perform "Sensitivity check" (Click here).

    Standard values:
    27 to 33 kg (59.52 to 72.75 lb)


NEXT

END