Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB (for 2WD)

FRONT AXLE HUB (for 2WD) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT AXLE HUB ASSEMBLY


2. INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY


    F043605
  1. Install the front suspension upper arm assembly with a new nut.

    Torque:
    110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }

  1. Install a new cotter pin.



3. INSTALL NO. 1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER


    F042737
  1. Install the No. 1 front suspension arm sub-assembly lower with the 2 bolts.

    Torque:
    160 N*m{ 1,630 kgf*cm , 118 ft.*lbf }



4. INSTALL TIE ROD END SUB-ASSEMBLY


    F043604
  1. Install the tie rod end sub-assembly with a nut.

    Torque:
    91 N*m{ 928 kgf*cm , 67 ft.*lbf }

  1. Install a new cotter pin.



5. INSTALL FRONT STABILIZER LINK ASSEMBLY


    C099158
  1. Install the stabilizer link with a nut to the steering knuckle.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



6. INSTALL FRONT DISC


7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY


    F043121
  1. Install the front disc brake caliper with the 2 bolts.

    Torque:
    123 N*m{ 1,254 kgf*cm , 91 ft.*lbf }



    F042731
  1. Install the brake tube bracket to the steering knuckle with a bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

  1. Using SST, connect the brake tube to the disc brake caliper assembly.

    SST
    09023-00101  

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }



8. INSTALL FRONT SPEED SENSOR


    F042730
  1. Install the speed sensor wire harness to the steering knuckle with a bolt.

    Torque:
    13 N*m{ 133 kgf*cm , 10 in.*lbf }

  1. Connect the 2 clips.

  1. Using a hexagon wrench, install the speed sensor with the bolt.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



9. BLEED BRAKE LINE


10. INSPECT FLUID LEVEL IN RESERVOIR


11. INSPECT BRAKE FLUID LEAKAGE


12. INSTALL FRONT WHEEL

Torque:
112 N*m{ 1,142 kgf*cm , 83 ft.*lbf }



13. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
(Click here)



14. INSPECT ABS SPEED SENSOR SIGNAL

HINT:
(Click here)