Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB (for 4WD)

FRONT AXLE HUB (for 4WD) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT AXLE HUB ASSEMBLY


2. INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY


    F043605
  1. Install the front suspension upper arm assembly with a nut.

    Torque:
    110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }

  1. Install a new cotter pin.



3. INSTALL NO. 1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER


    F042737
  1. Install the No. 1 front suspension arm sub-assembly lower with the 2 bolts.

    Torque:
    160 N*m{ 1,630 kgf*cm , 118 ft.*lbf }



4. INSTALL TIE ROD END SUB-ASSEMBLY


    F043604
  1. Install the tie rod end sub-assembly with the nut.

    Torque:
    91 N*m{ 928 kgf*cm , 67 ft.*lbf }

  1. Install a new cotter pin.



5. INSTALL FRONT STABILIZER LINK ASSEMBLY


    C099158
  1. Install the stabilizer link with a nut to the steering knuckle.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



6. INSTALL FRONT AXLE HUB NUT


    F042732
  1. Install the hub nut.

    Torque:
    235 N*m{ 2,396 kgf*cm , 173 ft.*lbf }

  1. Install the adjusting cap and cotter pin.



7. INSTALL FRONT AXLE HUB GREASE CAP


8. INSTALL FRONT DISC


9. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY


    F043121
  1. Install the front disc brake caliper assembly with the 2 bolts.

    Torque:
    123 N*m{ 1,254 kgf*cm , 91 ft.*lbf }



    F042731
  1. Install the brake tube bracket to the steering knuckle with a bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

  1. Using SST, connect the brake tube to the disc brake caliper assembly.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }



10. INSTALL FRONT SPEED SENSOR


    F042730
  1. Install the speed sensor wire harness to the steering knuckle with a bolt.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. Connect the 2 clips.

  1. Using a hexagon wrench, install the speed sensor with the bolt.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



11. BLEED BRAKE LINE


12. INSPECT FLUID LEVEL IN RESERVOIR


13. CHECK BRAKE FLUID LEAKAGE


14. INSTALL FRONT WHEEL

Torque:
112 N*m{ 1,142 kgf*cm , 83 ft.*lbf }



15. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
(Click here)



16. INSPECT ABS SPEED SENSOR SIGNAL

HINT:
(Click here)