Home › SUSPENSION & AXLE › AXLE › AXLE SYSTEM

AXLE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT AXLE HUB


    F042745
  1. Remove the front wheel.

  1. Remove front disc brake caliper (Click here).

  1. Remove the front disc.

  1. Inspect the axle hub backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the bearing.



    F042746
  1. Inspect the axle hub deviation.

    1. Using a dial indicator, check the distortion at the surface of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the deviation exceeds the maximum, replace the bearing.



2. INSPECT REAR AXLE HUB & BEARING ASSEMBLY


    F042747
  1. Remove the rear wheel.

  1. Remove the rear disc brake caliper (Click here).

  1. Remove the rear disc.

  1. Inspect the axle shaft backlash.

    1. Using a dial indicator, check the backlash near the center of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the bearing.



    F042748
  1. Inspect the axle shaft deviation.

    1. Using a dial indicator, check the distortion at the surface of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the deviation exceeds the maximum, replace the bearing.