DTC 01-D6 No Master |
DTC 01-D7 Connection Check Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| 01-D6 *1 | When either of the following conditions is met:
|
|
| 01-D7 *2 | When either of the following conditions is met:
|
| 1.CHECK RADIO AND NAVIGATION ASSEMBLY POWER SOURCE CIRCUIT |
| NEXT | |
| 2.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE |
![]() |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor" mode.
Identify the component which has stored this code.
| Display | Component |
| Rr-TV | Television display assembly |
| DSP-AMP | Stereo component amplifier |
| NEXT | |
| 3.CHECK POWER SOURCE CIRCUIT OF COMPONENT WHICH HAS STORED THIS CODE |
Inspect the power source circuit of the component which has stored this code.
If the power source circuit is operating normally, proceed to the next step.
| Component | Proceed to |
| Television display assembly (Rr-TV) | Television display assembly power source circuit (Click here) |
| Stereo component amplifier (DSP-AMP) | Stereo component amplifier power source circuit (Click here) |
| NEXT | |
| 4.CHECK RADIO AND NAVIGATION ASSEMBLY |
![]() |
Disconnect the radio and navigation assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ATX+ (R12-5) - ATX- (R12-15) | Always | 60 to 80 Ω |
| TXM+ (R11-9) - TXM- (R11-10) | Always | 60 to 80 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio and navigation assembly and the component which has stored this code.
Disconnect all connectors between the radio and navigation assembly and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio and navigation assembly and the component which has stored this code.

|
| ||||
| OK | |
| 6.REPLACE COMPONENT WHICH HAS STORED THIS CODE |
Replace the component which has stored this code with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||