Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY THE COMPONENT SHOWN BY SUB-CODE


  1. Enter the diagnostic mode.


    E110917E05

  1. Press the preset switch "3" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

HINT:
  1. "190 (radio receiver)" is the component shown by the sub-code in the example shown in the illustration.
  1. For details of the DTC display, refer to "DTC CHECK/CLEAR" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    Component Table: 
    Component
    Proceed to
    Television display assembly (1B0)
    Television display assembly power source circuit (Click here)
    Radio receiver (190)
    Radio receiver power source circuit (Click here)


NEXT


3.INSPECT RADIO RECEIVER


    E119766E04
  1. Disconnect the radio receiver connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    ATX+ (R1-5) - ATX- (R1-15) (*1)
    Always
    60 to 80 Ω
    TXM+ (R4-9) - TXM- (R4-10)
    Always
    60 to 80 Ω

    *1: 10 Speaker System



NG
REPLACE RADIO RECEIVER
OK


4.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  1. For details of the connectors, refer to "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the stereo component amplifier and the component shown by the sub-code.

    1. Disconnect all connectors between the stereo component amplifier and the component shown by sub-code.



    2. Check for an open or short in the AVC-LAN circuit between the stereo component amplifier and the component shown by the sub-code.

      OK:
      There is no open or short circuit.


      E119767E03



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE WOOFER BOX SPEAKER ASSEMBLY (BUILT-IN STEREO COMPONENT AMPLIFIER)
OK

END