CHASSIS > GENERAL MAINTENANCE |
| 1. INSPECT STEERING LINKAGE & GEAR HOUSING |
Check the steering wheel free play (Click here).
Check the steering linkage for looseness or damage.
Check that the tie rod ends do not have excessive play.
Check that the dust seals and boots are not damaged.
Check that the boot clamps are not loose.
Check that the steering gear housing is not damaged.
Check that the connector are properly connected to the steering gear housing.
| 2. INSPECT STEERING GEAR HOUSING OIL |
Check the steering gear housing oil leakage.
If leakage is found, check and repair the cause.
| 3. INSPECT BALL JOINT AND DUST COVER |
Inspect the ball joints for excessive looseness.
Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.
Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.
Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels.
Using a lever, pry up the end of the lower arm. Check the amount of play.
Check the dust cover for damage.
| 4. INSPECT DRIVE SHAFT BOOTS |
Check the drive shaft boots for loose clamps, grease leakage, kinks or damage.
| 5. CHECK AUTOMATIC TRANSMISSION FLUID |
Visually check the transmission for fluid leakage. If oil is leaking, find the cause and repair it.
| Type | See procedures |
| A750F | Click here
|
| A750E | Click here
|
| 6. INSPECT TRANSFER OIL (for 4WD) |
Visually check the transfer for oil leakage. If oil is leaking, find the cause and repair it.
| Type | See procedures |
| VF4AM | Click here
|
| VF4BM | Click here
|
| 7. INSPECT FRONT DIFFERENTIAL OIL SEAL (for 4WD) |
| 8. INSPECT REAR DIFFERENTIAL OIL |
| 9. INSPECT FRONT AND REAR SUSPENSION |
| Type | See procedures |
| Front Suspension | Click here
|
| Rear Suspension | Click here
|
| 10. LUBRICATE PROPELLER SHAFT AND TIGHTEN BOLTS |
4WD:
Lubricate propeller shaft, referring to the lubrication chart. Before pumping in grease, wipe off any mud and dust on the grease fitting.

| Spider | Lithium base chassis grease NLGI No. 2 |
| Slide yoke and double-cardan joint | Molybdenum disulphide lithium base chassis grease NLGI No. 2 |
Tighten the bolts for propeller shaft.
| Type | See procedures |
| 2WD | Click here
|
| 4WD | Click here
|
| 11. ROTATE TIRES |