Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1253/53    Hydro Booster Pump Motor Relay Malfunction

for Preparation Click here


DESCRIPTION

The motor relay (semiconductor relay) is built in the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1253/53
Motor system circuit (motor input circuit)
  1. Hydraulic brake booster pump motor
  2. Hydraulic brake booster pump motor circuit

WIRING DIAGRAM


C132922E03


INSPECTION PROCEDURE

NOTICE:
When replacing the hydraulic brake booster (master cylinder solenoid), perform zero point calibration (Click here).

1.PERFORM ACTIVE TEST BY INTELLIGENT TESTER (H/B MOTOR RELAY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and push the intelligent tester main switch ON.

  1. Start the engine.

  1. Select "ACTIVE TEST" mode on the intelligent tester.

    Item
    Vehicle Condition / Test Details
    Diagnostic Note
    H/B MOT RELAY
    Turns H/B motor relay ON / OFF
    Operation sound of motor can be heard

  1. Check operation sound of the H/B motor individually when operating it with the intelligent tester.

    OK:
    The operation sound of the H/B motor can be heard.



OK
Go to step 4
NG


2.INSPECT SKID CONTROL ECU (+BM TERMINAL)


    C124799E15
  1. Disconnect the skid control ECU connectors.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    S28-2 (+BM1) - Body ground
    10 to 14 V
    S29-2 (+BM2) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (+BM CIRCUIT)
OK


3.INSPECT SKID CONTROL ECU (GND TERMINAL)


    C124799E16
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S28-1 (GND1) - Body ground
    Below 1 Ω
    S28-32 (GND2) - Body ground
    Below 1 Ω
    S29-4 (GND3) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK


4.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to the ON position.

  1. Wait until the pump motor stops.

  1. Depress the brake pedal several times until the pump motor turns on.

  1. Wait until the pump stops.

  1. Repeat (f) and (g) 3 more times.

  1. Check if the same DTC is detected (Click here).

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.


    Result:

    Condition
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE HYDRAULIC BRAKE BOOSTER