Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1256/56    Accumulator Low Pressure

for Preparation Click here


DESCRIPTION

The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.

C124776E03


DTC No.
DTC Detecting Condition
Trouble Areas
C1256/56
Fluid pressure inside the accumulator is below the standard value.
  1. Hydraulic brake booster
  2. Hydraulic brake booster pump motor
  3. Hydraulic brake booster pump motor circuit
  4. Accumulator pressure sensor

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

HINT:
When C1251/51, C1253/53, or C1254/54 is output together with C1256/56, inspect and repair the trouble area indicated by C1251/51, C1253/53, or C1254/54 first.

1.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to the ON position.

  1. Wait for 99 seconds.

  1. Check if the same DTC is detected (Click here).

    Result:

    Condition
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    HINT:
    Excessive brake pedal operation results in abnormal accumulator pressure consumption. This is normal.



B
END
A


2.CHECK HYDRAULIC CIRCUIT
  1. Check the hydraulic circuit (Click here).

    OK:
    Hydraulic circuit is normal (No leakage).



NG
REPAIR HYDRAULIC CIRCUIT
OK


3.READ VALUE OF INTELLIGENT TESTER (ACCUMULATOR PRESSURE SENSOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and push the intelligent tester main switch ON.

  1. Select "DATA LIST" mode on the intelligent tester.


Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
ACC PRESS
Accumulator pressure sensor reading / Min.: 0 V, Max.: 5 V
3.58 to 5 V
If the value is constant regardless of pump operation, accumulator pressure sensor malfunction is suspected.
  1. Check that the accumulator's output value is normal.

    OK:
    Accumulator pressure sensor value is normal.



NG
REPLACE MASTER CYLINDER SOLENOID
OK


4.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is detected (Click here).

    Result:

    Condition
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID