VEHICLE STABILITY CONTROL SYSTEM > Brake Warning Light Remains ON |

| 1.CHECK DTC |
Check the DTCs (Click here).
| Condition | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.INSPECT IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check the skid control ECU connector's connecting condition.
|
| ||||
| OK | |
| 3.INSPECT BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 4.INSPECT SKID CONTROL ECU (IG1 TERMINAL) |
![]() |
Disconnect the skid control ECU connector.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S28-46 (IG1) - Body ground | 10 to 14 V |
|
| ||||
| OK | |
| 5.INSPECT SKID CONTROL ECU (GND TERMINAL) |
![]() |
Disconnect the skid control ECU (S29) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S28-1 (GND1) - Body ground | Below 1 Ω |
| S28-32 (GND2) - Body ground | Below 1 Ω |
| S29-4 (GND3) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 6.INSPECT PARKING BRAKE SWITCH |
![]() |
Disconnect the parking brake switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P4-1 - Body ground | Parking brake switch ON (Switch pin free) | Below 1 Ω |
| P4-1 - Body ground | Parking brake switch OFF (Switch pin pushed in) | 10 kΩ or higher |
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - PARKING BRAKE SWITCH) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S28-28 (PKB) - P4-1 | Below 1 Ω |
| S28-28 (PKB) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 8.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER) |
![]() |
Disconnect the combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S29-3 (BRL) - C11-2 | Below 1 Ω |
| S29-3 (BRL) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 9.INSPECT COMBINATION METER ASSEMBLY |
Check the combination meter system (Click here).
|
| ||||
| OK | ||
| ||