VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light does not Come ON |

| 1.INSPECT SLIP INDICATOR LIGHT |
Disconnect the skid control ECU connector.
Ground terminal IND of the skid control ECU.
Turn the ignition switch to the ON position.
Check that the SLIP indicator light comes on.
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER) |
![]() |
Disconnect the combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S28-34 (IND) - C10-20 | Below 1 Ω |
| S28-34 (IND) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT COMBINATION METER ASSEMBLY |
Check the combination meter system (Click here).
|
| ||||
| OK | ||
| ||