Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C0226/21    SFR Solenoid Circuit

DTC    C0236/22    SFL Solenoid Circuit

DTC    C0246/23    SRR Solenoid Circuit

DTC    C0256/24    SRL Solenoid Circuit

DTC    C1225/25    SMC Solenoid Circuit

DTC    C1226/26    SPC Solenoid Circuit

DTC    C1227/27    SRC Solenoid Circuit

DTC    C1228/28    STR Solenoid Circuit

for Preparation Click here


DESCRIPTION

The solenoid goes on when signals are received from the ECU and controls the pressure acting on the wheel cylinders, thus controlling braking force.

DTC No.
DTC Detection Condition
Trouble Area
C0226/21
Open or short circuit in SFRH or SFRR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SFRH or SFRR circuit
C0236/22
Open or short circuit in SFLH or SFLR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SFLH or SFLR circuit
C0246/23
Open or short circuit in SRRH or SRRR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SRRH or SRRR circuit
C0256/24
Open or short circuit in SRLH or SRLR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SRLH or SRLR circuit
C1225/25
Open or short circuit in SMCF circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SMCF circuit
C1226/26
Open or short circuit in SREA circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SREA circuit
C1227/27
Open or short circuit in SREC circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SREC circuit
C1228/28
Open or short circuit in STR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. STR circuit

WIRING DIAGRAM


C132912E01


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.RECONFIRM DTC

HINT:
These codes are detected when a problem is determined in the master cylinder solenoid.
The solenoid circuit is in the master cylinder solenoid.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.

  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are detected (Click here).

    Result:

    Condition
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID